newbie......bluetooth gps settings

newt · Occasional Visitor Joined: Sep 21, 2003 Posts: 24

hi.....plan to use my ipaq 1940 with a bluetooth receiver and tt 3.......what settings do i use in the gps setup.......

i have

COM 3
BLUETOOTH SERIAL COM 8
BLUETOOTH SERIAL COM 5
S2410 IRDA2410
S2410 COM 0
SERIAL ON USB

also which gps driver would you recommend to use......would 2.07 work

thanks

ivan · Occasional Visitor Joined: Sep 21, 2004 Posts: 5

hi there

dont know if this helps but i got 1940 and got the tomtom3 gps reciever and works well together !

so on that i would say stick with the best !

cheers
ivan

Privateer · Posted: Wed Sep 22, 2004 11:00 pm Post subject:

Hi Newt,

TT GPS Driver 2.07 is a good one to use.

NMEA 0183v2 38400 is a good start too.
Try either of your Bluetooth COMs.

Don’t forget to pair you BT receiver with your iPAQ 1940 as well.

Regards,
_________________
Robert.
iPhone 6s Plus, iOS 14.0.1: iOS CamerAlert v2.0.7
TomTom GO Mobile iOS 2.3.1; TomTom (UK & ROI and Europe) iOS apps v1.29
Garmin Camper 770 LMT-D

Baldlygo · Posted: Thu Sep 23, 2004 9:54 am Post subject:

Like Ivan I also have iPaq 1940 with TT3 Bluetooth.
It installed well out of the box and all worked without me knowing how!

I did run into problems when I also installed Memory-map.

The default TT3 installation automatically picked up NMEA - Bluetooth COM8 which is fine if you only run TT however TT locks the port COM8 (even when it is not running).

TT support sent me an older GPS driver which now allows me to run both apps. (one at a time of course!).

	PocketGPS
	Web