Icn 630 Smart ST V3 question

[paulj999]

I have just had a nightmare installing V3. Inbetween it rebooting my PC whilst uploading the maps. Then XP telling me its recovered from a serious error due to a device driver !

Then the blue USB connect screen when I switch the on !

Also Smart ST desktop keeps telling me there is an update over and over again ! Arrrghh

So what version should I be on now...
3.00.1009
English 3.01.003
Tcore v1_16_0039 2004/11/05-14:15:49

Can anybody tell me if this sounds about right ?

[DigDug]

Paul,

That looks about right. I also had a nightmare installing V3.0. Problem was due to either a) PC USB hardware or b) Other software installed.

Question:

Are you able to boot your iCN and load V3.0 or do you only get the USB connect screen on the iCN?

That is what I experienced and fixed it by re-installing the desktop software on a different PC and going through the installation process on the iCN again.

[paulj999]

I initially got the blue usb screen on switch on but after doing another install on the same PC the icn boots ok.

The only other USB device I have plugged in is my MS intellimouse optical. I wonder if this is the cause. I will have to try with my ps2 mouse.

I also sometimes use the USB cyborg evo joystick and USB Digi camera.

Will have to dust off my Emergency PC !!

Can't go back to maps anymore !!

We see you’re using an ad-blocker. We’re fine with that and won’t stop you visiting the site.
Have you considered making a donation towards website running costs?.
Or you could disable your ad-blocker for this site. We think you’ll find our adverts are not overbearing!