Setting up Checkpoint 5 on Ipaq hw6515

richard_c

I have recently installed Checkpoint 5 on my Ipaq hw6515 but whenever I run it & try to set it up all I keep getting is the following message when I try to Synchronize:

"Before you can synchronize, the map used by TomTom Navigator has to be known to CheckPOint. Please press the Navigate button first to make that happen."

When I press the Navigate button, Tomtom loads up and nothing else happens and I get same message again and again & all options for synchronizing are greyed out.

Is this a Windows 2003 Mobile edition problem, or something else?

lbendlin · Posted: Thu Sep 01, 2005 2:18 am Post subject:

Are you running the ROM version of TomTom? That may not be compatible with Checkpoint 5
_________________
Lutz

Report Map Errors here:
TomTom/TeleAtlas NAVTEQ

richard_c · Posted: Thu Sep 01, 2005 2:53 am Post subject:

lbendlin · Posted: Thu Sep 01, 2005 2:58 am Post subject:

no, you should be fine then.

Have a look if the iPAQ has a folder \My Documents\TomTom and if that folder contains a file "currentmap.dat"
_________________
Lutz

Report Map Errors here:
TomTom/TeleAtlas NAVTEQ

richard_c · Posted: Thu Sep 01, 2005 3:03 am Post subject:

lbendlin · Posted: Thu Sep 01, 2005 3:42 am Post subject:

Hmm... that's where CheckPOint should take their wisdom from as to which map is loaded. I fear you'll have to ask them guys directly. From here your setup looks a-ok.
_________________
Lutz

Report Map Errors here:
TomTom/TeleAtlas NAVTEQ

richard_c · Posted: Thu Sep 01, 2005 4:03 am Post subject:

Thanks for your help.

I will give them a try.

	PocketGPS
	Web