V3 to V2 Software

gasdiver · Occasional Visitor Joined: Jul 05, 2005 Posts: 6

I have reinstalled V2 software because I am off to Spain and don't have full European access to my maps. I have tried to load the maps and had an issue with the V2 maps not been registred and "error code 0" kep comming up. I looked on the Navman site and downloaded the file "rfnr.nvm" and this cleared the problem, however, when I Install the maps everything seems to work but when I switch on the unit there are no maps Installed.

Please help Sad

I go on Tuesday

gasdiver · Occasional Visitor Joined: Jul 05, 2005 Posts: 6

Sorry, it's an ICN 630

Tim Buxton · Posted: Sun Jul 24, 2005 4:00 pm Post subject:

Just out of interest, why did you reinstall the V2 software? Your V2 maps should work with your V3 software.
_________________
Tim

gasdiver · Occasional Visitor Joined: Jul 05, 2005 Posts: 6

Because I only have UK access on my V3 software. I will have to pay £79 to get access to Spain.

gasdiver · Occasional Visitor Joined: Jul 05, 2005 Posts: 6

Managed to sort it, I did not realise you can use V3 software and load V2 maps onto unit. All sorted and thanks Laughing

	PocketGPS
	Web