Hard wiring kit into new car

Mac1 · Occasional Visitor Joined: Aug 30, 2004 Posts: 7

Hello all, I'm picking up a new car this week with a heat reflecting windscreen and want to fit in my ipaq without wires all over the place. At the moment i have wired tt3 with a 2210 but want to do a much neater job.

1
I plan to get a hard wired brodit holder with built in speaker, this looks easy enough, is the speaker any good ?

2
I need to get a bluetooth reviever, no idea which one but I'd prefer one with some kind of in car charger.

3
I have to get some kind of antenna because of the heat reflecting windscreen and would also prefer one with a charger.

4
With this antenna fitted can i hide the bluetooth reciever somewhere in the boot.

5
I plan to run the power for the bluetooth reciever and antenna off of a distribution block used for a stereo amplifier in the boot, i assume this is ok as it will already be there and once again lets me hide everything.

While the budget for this system is not limitless i want to do it right as its a brand new car and I want to do a good job.

Any advice as to if I can do what I want to would be much appreciated. In addition pointers on which components to do it with would be most welcome.
Thanks in advance.

Mac1 · Occasional Visitor Joined: Aug 30, 2004 Posts: 7

anyone ?

Mac1 · Occasional Visitor Joined: Aug 30, 2004 Posts: 7

	PocketGPS
	Web