Navman ICN510 Speed Camera POI's

PadiSteve · Occasional Visitor Joined: Dec 12, 2004 Posts: 3

Can anyone help, this is driving me nuts - my brother has bought a Navman ICN510 then brought it round for me to add speed cameras. I went to the site, downloaded the camera file unzipped it, followed the instalation instructions to the letter and every time at the last minute i get "no POI found in input file" - I've looked in the forum and the only tip I can see is to replace the @ sybol with at which I've done, but the result is exactly the same. Does anyone know whats wrong & how to correct it. Crying or Very sad

PadiSteve · Occasional Visitor Joined: Dec 12, 2004 Posts: 3

Got it - The answer is not to use excel to edit the file. Use notepad and everything works fine. :D

AusS2000 · Occasional Visitor Joined: Dec 16, 2004 Posts: 8

I had the same problem. Should have known it would be Excel.

Are you using the @ or 'at' symbol and is this for entering speed limits?

Where does it go?

PadiSteve · Occasional Visitor Joined: Dec 12, 2004 Posts: 3

Don't use EXCEL - Use Notepad. then the only editing necessary is to remove the first line then save the file. "Save to device". That should install it on the navman - Good luck.

	PocketGPS
	Web