Assert failure

AJ22 · Posted: Mon Oct 30, 2006 8:22 pm Post subject: Assert failure

Hi all,

I am new to the forum and a new owner of a Navman iCN520. Please can anyone assist?, I have a new 'Assert Failure' (as I have checked other posts and can not find it) it is as follows;

Navigator\GUI\Unstable\App\DestWizard.c
Line:2004 Test:Country Result!=NULL

Can anyone assist me with a solution?

Please note that I have updated the Navman software via the Navman website (so the other Assert Failures should be ok) and I have also upgraded to a 1Gb SD card. I have a feeling it may be linked to this but have not got a clue.

Many thanks.

DRP · Posted: Mon Oct 30, 2006 8:40 pm Post subject:

Hi and welcome.
Is your new card fitted in the unit properly? If you remove the card wiles the unit is switched on you will get an assert failure. What read write speed is you new card, how many maps POI’s are on it, do you need them all active?
Regards
DRP
_________________
Sharing information is the key to a better understanding

Mio M400 WEU, N60I, T1, 2x B2, iCN 510 & lots more

AJ22 · Posted: Mon Oct 30, 2006 11:39 pm Post subject:

AJ22 · Posted: Mon Oct 30, 2006 11:46 pm Post subject:

AJ22 · Posted: Tue Oct 31, 2006 12:06 am Post subject:

Sorry, not sure why I have posted twice!!

I have reduced the amount of active POI's ands now I have an egg timer hanging there and nothing happening, I have tried resetting etc and still have the egg timer hanging there. Any suggestions please?

Gee-Pee · Posted: Tue Oct 31, 2006 9:55 am Post subject:

Just a couple of suggestions/queries.

1. Did you format the new card in FAT.

2. Is the card described as an Ultra or High speed card because although Navman say 512Mb largest card to use you can use larger so long as it is 'High Speed'

3. Have you tried putting your old card back in the device and hard resetting the device to ensure it works OK without the new card?
_________________
Gee-Pee
Lifetime member PGPSW - time rapidly decreasing

AJ22 · Posted: Wed Nov 01, 2006 1:04 pm Post subject:

DRP · Posted: Wed Nov 01, 2006 8:00 pm Post subject:

Hi
As a last option you could perform a reinstall of the software on the iCN. As long as you have the cd’s and you are the registered owner. After the install you will need to get you registered info from Navman by clicking on the tools icon on SmartST desktop.
You will find how to do it on page 69 of the user manual. The manual can be found under help on SmartST desktop. Make a backup of you iCN before doing anything.
Regards
DRP
_________________
Sharing information is the key to a better understanding

Mio M400 WEU, N60I, T1, 2x B2, iCN 510 & lots more

	PocketGPS
	Web